Our blog

Follow us on other social networks.

How To Save Your Water-Damaged Wood Floors

Water Damage Floor Restoration

Flooding and hardwood flooring don't mix. For anyone who lives in hurricane- and flood-prone areas that have historic homes, this is no surprise.

Is there anything you can do if major amounts of water--flood-related or not--have come into contact with your wood floor? Yes. While your floors will never be quite the same as new again, you can take appreciable efforts towards saving them from the junkyard.

While your local architectural salvage yard might love to have your pulled-up hardwood flooring, it's not time for them to give up the ghost just yet.

While Floors Are Still Wet (Before Mold and Mildew)

As soon as you can attend to your wet floors, the better. Wood's cellulose fibers rapidly soak up water but only slowly releases that water. So, you want to start pulling off the water with your shop vacuum fast. Even if you believe your wood floors are so well-finished that water cannot penetrate the raw wood, think again. Wood floors have many infiltration points besides the top layer--between seams, through breaks in the coating, under baseboards, through heating registers, and a host of other areas.

The secret to preventing mold and mildew growth is the same as with carpeting: eliminate the dirt. It's not just water that causes mold and mildew; it's the combination of water and dirt.

Tools Needed:

  • Shop vacuum
  • Stiff Brush or Broom
  • Mild Detergent
  • Bucket
  • Disinfectant (like Mr. Clean, etc.)
  • Absorbent Cloth

First, use the shop vacuum on "wet mode" (no bag) to remove as much water as possible. Then vigorously scrub all floors and related woodwork (baseboards, newel posts, etc.) with the stiff broom or brush.

Use fresh water mixed with detergent and disinfectant added, to remove all of the dirt, mud, silt, and organic material which can later cause mold and mildew.

If Mold and Mildew Have Set In

If the wood is heavily affected by mold and mildew, it may need to be replaced. Otherwise, clean your moldy and mildewed flooring like this:

Tools Needed:

  • Stiff Brush or Broom.
  • TSP (trisodium phosphate).
  • Bucket.
  • Absorbent Cloth.
  • Rubber Gloves.
  • Optional: Bleach; Mild Abrasive like Barkeeper's Friend

TSP is a super-cleaning product that comes in the form of a powder that can be added to water (4-6 tablespoons per gallon). You can buy this at your local hardware store. Don't worry: it sounds harsher than it really is.

Scrub with the water/TSP solution until mold and mildew are removed, then rinse with clear water and allow to dry.

It helps the "healing process" if you can remove any pooled-up water from your cleaning efforts as soon as possible, rather than waiting for evaporation. A rubber push squeegee or shop vacuum will do the trick.

For Mold on Wood Under Paint

This is a trickier issue. Your only recourse at this point is to remove the finish.

For problem areas, you may want to scrub the wood with an abrasive cleaner like Barkeeper's Friend.

Or, to the water/TSP solution listed earlier, you can boost the mold- and mildew-cleaning properties by adding one cup of ordinary laundry bleach per gallon of water.

Drying Procedures

As you might imagine, the drying of damaged wood flooring must be done slowly. Wood flooring dried quickly invariably will crack.

In general, you will want to remove as much standing water as possible, and then accelerate the evaporation process with fans. Do not apply any type of heat to the hardwood flooring, as splitting, cupping, and a host of other problems will result.

Sanding Water-Damaged Wood Flooring

After drying, you may have some concave or convex floorboards; this is called "cupping."

Heavy sanding with a drum or orbital sander can actually "take down" some minor high areas. Heavily cupped wood cannot be sanded down flat.

It is inevitable that some floorboards may lift up completely at the ends. In this case, face-nail the floorboards back down.

Bottom Line

The key to "saving" your wood floors is expediency. Because wood is an organic material, the more time it is in contact with water, the worse the problem will get. Remember that you need to expel the dirt and other organic matter to prevent mold and mildew. Removing water alone will not prevent these issues.

If you can get to the flooring right away, you can get your flooring back to "almost like-new" condition.

Source: thespruce

Floor Floor We Restore has re-established the attractiveness in hundreds of homes and businesses throughout the Houston Area for Over 20 Years. Since 1984, we have provided maintenance and restoration that is essential to the beauty of floors and surfaces everywhere. With 30+ years of experience and never using subcontractors, we have perfected our trade to better serve you. We are a locally, family owned and operated company who GUARANTEE all of our work..

Water Damage Floor Restoration.

Floor Floor We Restore, marble flooring in Houston, hardwood floor restore in Houston, Houston restore hardwood floor, Houston restore hardwood floor shine, restore wooden floor, restore a floor reviews, restore floor tiles, wood floor restore, floor restorers, floor restore and more, floor restorer, hardwood restore, stone restore, slate restore, saltillo restore, tile restore, grout restore, terrazzo restore, travertine restore, floor surface restore, floor recovery, cleaning hardwood floors, hardwood floor polish, buffing floor, water damage floor restoration, sand and finish hardwood flooring, hardwood floor installation, hardwood floor repair, hardwood floor installation, hardwood floor repair, hardwood floor installation, hardwood floor repair.

Opening Hours

Monday – Friday: 8am – 6pm
Saturday – Sunday: 8am – 6pm

About Us

Floor Floor We Restore has re-established the attractiveness in hundreds of homes and businesses throughout the Houston Area for Over 20 Years.